INSTALLATION MANUALSAVE THIS MANUALINSTALLATION & OPERATING INSTRUCTIONSFOR RP007 - 060 SERIES WATER SOURCE HEAT PUMPS 036-21521-001-A-0103RP007
036-21521-001-A-010310 Unitary Products GroupCONDENSATE DRAIN PIPINGHorizontal Units - The 3/4 FPT drain connection on the unit is NOT internally trap
036-21521-001-A-0103Unitary Products Group 11circulating fan will cycle on and off with the compressor. If desired, the air circulating fan can be ru
036-21521-001-A-010312 Unitary Products GroupPeriodic lockouts are almost always caused by air or water problems. The lockout of the compressor is a n
036-21521-001-A-0103Unitary Products Group 13 FIGURE 2 : TYPICAL SINGLE PHASE WIRING DIAGRAMAPPLIES TO ALL208/230-1-60 SINGLEPHASE MODELSNote: Soleno
036-21521-001-A-010314 Unitary Products Group FIGURE 3 : TYPICAL THREE PHASE WIRING DIAGRAMAPPLIES TO MODELS:RP030, RP036, RP048& RP060NOTE: Sol
036-21521-001-A-0103Unitary Products Group 15 FIGURE 4 : HORIZONTAL MODELS - DIMENSIONSTABLE 7: HORIZONTAL MODELS - DIMENSIONSABCDEFRETURN AIRKSUPP
Subject to change without notice. Printed in U.S.A.Copyright © by Unitary Products Group 2003. All rights reserved. Supersedes: Nothing 036-21521-001-
036-21521-001-A-01032 Unitary Products GroupTABLE OF CONTENTSPRODUCT NOMENCLATURE . . . . . . . . . . . . . . . . . 3INTRODUCTION . . . . . . . . .
036-21521-001-A-0103Unitary Products Group 3 INTRODUCTIONRP units are completely self-contained heating and/or air conditioning units. This equipment
036-21521-001-A-01034 Unitary Products GroupPRE-INSTALLATION INSPECTION OF EQUIPMENTAll units are factory tested to ensure safe operation and quality
036-21521-001-A-0103Unitary Products Group 5NOTE:1. Performance calculated in accordance with ARI/ISO Standard 13256-1 for Water Loop application.2. C
036-21521-001-A-01036 Unitary Products GroupCLEARANCES REQUIREDTwenty-four (24) inch clearance is required on all sides of the unit for service access
036-21521-001-A-0103Unitary Products Group 7The power supply wiring is to be connected directly to the line side of compressor contactor as shown on t
036-21521-001-A-01038 Unitary Products GroupBLOWER PERFORMANCEAll units employ direct-drive blower motors with multi-ple speed taps available. The mot
036-21521-001-A-0103Unitary Products Group 9LOOP WATER SUPPLY AND PIPING CONNECTIONSThe recommended circulating water supply for heat pump systems is
Comments to this Manuals